Polar D 66 series 26.4" Paper Cutter
The sturdy, programmable cutter POLAR D 66 is designed for one-shift operation. The precise swing cut is carried out hydraulically. Thus, the time of the knife spent in the lower dead end can be adapted to the material. The ultra-smooth stainless table surface allows an easy handling of the material even without air jets. Within a wide setting range the clamping pressure can be adjusted infinitely to each cutting material by means of a turning knob with scale. Bright LEDs mark the cutting line clearly visible for the operator.
Model variants:
ECO: 5.5“ monochrome display and extra low-profile keyboard
PLUS (shown in photo): for the integration into the digital workflow with 18.5” touch-screen display and process visualization
- False clamp plate
- Eccentric knife leveling
- Non-corrosive stainless steel table
- No slot in table
- Powered backgauge with direct positioning
- Fully hydraulic knife and clamp
- Fraction input w/automatic decimal conversion
- Adjustable clamp pressure
- Lifetime cut counter
- Quiet operation, hydraulic pump runs only during cutting
- Adjustable knife cycle timing
- Infrared safety beams are standard
- Two-hand, timed cut release with non-repeat device
- Rear table fully covered
- Permanent check of knife position
- Machine self-diagnosis with error indication
Specifications
Maximum Cutting Width: 26.4" / Minimum Cut without false clamp plate: 0.59" / Minimum Cut with false clamp plate: 1.97" / Maximum Cut Depth: 26.4" / Clamp Opening without false clamp plate: 3.94" / Clamping Method: Hydraulic and Manual / Maximum Clamping Force: 3,300 lbs. / Backgauge Control: Power
Dimensions
72" D x 50" W x 59" H / Net Weight: 1,356 lbs. / Shipping Weight: TBA
Electrical
200-240 VAC 3-phase (25A) or 1-phase (32A) available